AC to DC conversion

-
Why bridge rectifier mostly used for AC to DC conversion? 

Bridge rectifier are mostly used AC to DC conversion because peak inverse voltage rating of diode in bridge rectifier is half than that of needed in Centre tapped full wave rectifier . Diode used in bridge rectifier are capable of Bearing Heig pick inverse voltage. 

Comments

Post a Comment

Popular posts from this blog

definition

-
Explain the following terms:- Tree :- it is a inter-connected open set of branches which include all the nodes at a given graph without forming any closed path.  Co- Tree :- From the oriented graph, if a tree is removed, the resultant is known as co tree or complement of tree.  Link :- It is a branch of a graph which does not belong to the particular tree, known as link . The link are present in the tree.  Graph :- The graph is also called as the collection of different points called as the node and different lines called as elements. These buses are interconnected through elements.  Nodes :- A point where two or more circuit elements branches meet is called a node.  Loop : - loop is a closed path of a circuit but all match are loops and the loop is not necessarily a mesh. 
Read more

planar and non planar

-
Image
What is the difference between planar and non- planar graph?  PLANNER GRAPH :- • A graph in which the direction of current or direction or of Edge is given is called planar graph.  • planar graph is also known as oriented graph.  Non-Planar graph:- •  A graph in which the direction of current age is not given is called Non - Planar graph.  • Non- planar graph is also known as unoriented graph. 
Read more

center tapped and conventional Transformer

-
Image
Differentiate between Centre tapping Transformer and conventional transformer ?  Centre tapped Transformer gives us different range of voltage at secondary side whenever required to operate at different loading condition but normal Transformer gives us some fixed voltage at secondary side irrespective of loading condition. Centre tap Transformer always have tapping on hai higher voltage side because on the HV side current is low compared to LV side. So transition of moving arm on hand to change tap will cause in large change in current. 
Read more